Schlage LE & NDE Lock Requirements

This topic lists the requirements needed to integrate LE/NDE Locks with System Galaxy.

 

Requirements

  1. NDE/LE Locks can be installed on a system that has AD-Series Locks (AD300/AD400).

  2. System Galaxy 10.5.1 with v10.5.3 S28 Flash (or higher).

  3. 635-CPU and 635-DSI running the correct flash that pairs with the SG software.

  4. Gateway Module must be set for 2-wire communication (jumpers must be installed correctly).

  5. Gateway Modules must be powered from an external power supply or the power adapter that comes with the device supplied. Do not power a Gateway from the 635-DSI board.

  6. Download the ENGAGE Mobile App before you begin. Sign in using the online account credentials that you create at Allegion’s portal ( http://portal.allegionengage.com/partner). A valid email must be supplied.

  7. You must commission each Gateway into a site in the Engage app. Gateway IDs must be unique and valid (1-16 is valid; 0 is not supported). Gateway high/low ranges cannot overlap each other.

  8. You must add a Lock to the Engage app and the link it to a Gateway. Lock number must be unique and valid (1-16 is valid; 0 is not supported). Lock number cannot exceed the Gateway high/low range.

  9. You can use the engage app to upgrade Gateway and Lock firmware as needed.

  10. System Galaxy DSI Reader count must be correctly registered in the SG software.

  11. Once locks are configured, you will program the 635-DSI section in the System Galaxy Serial Channel Programming screen.

  12. You can program reader settings for each NDE/LE Lock in System Galaxy Reader Properties.

  13. ABOUT RESETTING A LOCK: If a lock will not show up in the Engage app when you cycle the REX, then the lock must be reset. The reset is done by removing the battery compartment cover and holding the reset button until the reader beeps. Release the button and cycle the REX lever three times. You should see a flashing LED on the reader.